Paint RSGT letter blocks into the rail and band lattice, then lay the pattern on a singlet.
Each slanted slot is one 1× pixel: 4 cells across, 1 band tall. Brushes 1× and up snap to any slot; ½× and ¼× snap to their own half and quarter slots. Right-click or hold Alt to erase.
Choose Hero next to Paint and Erase, then click painted blocks to make them stand out. Click a hero again to make it a normal block.
At the hero the colours are fully reversed: the background takes the hero colour and the lines take the background colour. Over the blur radius they fade back to normal. Set the hero colour in Colour on the right.
Reach limits how far the rails and band lines run out from the letter blocks, measured in bands. Ragged ends staggers where each line stops, so the lattice dissolves instead of ending in a hard edge. Set reach to the maximum for the full lattice.
A template can hold one panel or a front and a back side by side. Each closed outline is scaled so its width matches the chest width above.
Distances use normal eyesight: a line is resolvable down to about 1 arcminute (0.29 mm per metre). It reads clearly at about 3 arcminutes. Lettering assumes 25 mm of letter height for every 3 m of viewing distance.
The SVG is in real millimetres. Layers: background, pattern ink and, when cropped, the singlet outline as a thin guide. With crop on, the ink is cut to the outline itself, not just masked. The Merge Fillet export uses the uncropped pattern at one bleed size.